Man, this is a great list.
I can use more advice. I'm putting new rear wheel cylinders on. The workshop
manual talks about a retaining plate and a spring plate, both of which I've
managed to put on over the rubber dust cover (with the help of silicone
grease).
But the picture breakout in my workshop manual shows a "distance piece" that
should be going over the top of the retaining plate. Yet it seems to me that
there is absolutely no room left for the distance piece.
Am I missing a step? Should I grind the POR 15 from the back plate and try
again (it's not that thick)? Or is the distance piece optional for if you
need it? Or maybe there's a trick for installing them?
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|