>simple.(TR6 questions).
>Pinning thrust washers,yea or nay.
**************************
If it properly set up you shouldnt need to, but if done correctly I see
nothing wrong with it. Plus it adds a little piece of mind
*************************
>Spitfire cam bearings,yea or nay
*************************
I am assuming that you are referring to installing cam bearings in the
block - good idea, not absolutely necessary but better than riding in the
cast iron
*************************
>Any advice regarding severe pitting on camshaft and lifters?
*************************
REPLACE THEM - no short cuts here, if they are pitted they are gone - and
you can't just smooth the lifters bottoms. They are ground with a very
slight crown in them which you wont be able to reproduce by simply lapping
them on a flat surface - Replace these items - with that much work
involved, not to mention expense, it isnt worth having to do it all over
again when, not if it fails
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|