List,
I'm in the process of installing modern oil seals on the front hubs of
my '75 TR6. I'm doing it to replace the felt seals in an effort to
reduce the excessive end play in my front wheel bearings.
My question is which way 'round should the new oil seal go? Open side in
or out? I installed mine open, or lip side out. This may be obvious to
everyone but me, but I just want to be sure before I button everything
up.
TIA,
Jim Davis
Fortson, GA
CF38690UO
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|