> What's my best bet for replacing this -- I assume the bezel won't
> fit tight
> against the glass unless some type of material is added. I was thinking
> about gasket material or maybe fashioning a seal out of clear
> silicone caulk.
> Any other thoughts?
Think O-ring.
TRF et al sell O-rings sized to fit between the gages and the dash, they
seem to work pretty good between the bezel and glass too.
Or, you can just buy a length of small diameter O-ring material and cut it
to length.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|