Does anyone have any suggestions on how to fit the rubber dust boots around
the front calliper pistons? I am rebuilding my callipers and have new
pistons and a seal kit. No problem fitting the seal and the piston fits
nicely without the boot but I can't get the boot lip to fit in its groove in
the calliper body. The callipers are the type that don't use the wire
retaining ring. Possible problems: Poor fitting after market parts, old
dried up rubber, ??? What about using a brake pad spreader to force the
piston and boot into place?
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|