----- Original Message -----
From: ptegler@cablespeed <ptegler@cablespeed.com>
> The problem is the seal is not 'shaped' to the window.
> It is simply one long extrusion of rubber. The outer most
> lip that is most visible is thin and splits rather quickly.
>
> (this is the seal on the glass of a Triumph GT6 rear hatch)
Continuous extrusions should be engineered to cope with a specific minimum bend
radius. As such, the rubber used for this would not be an identical compound to
that used in a fully formed seal with moulded corners. My own recommendation
where a seal is forming a tight radius, is to cut the seal to a generous length
so that the inside of the bend is compressed, reducing the tension of the
outside of the bend. Also use plenty of your preferred sealant at the outside
of the bend - this will help adhere the outside edge to the frame, again
reducing the possibility of splitting.
Cheers,
Bill.
--
Rarebits4classics
.......just what you've been looking for
PO Box 1232
Calne
Wiltshire
SN11 8WA
United Kingdom
http://www.rarebits4classics.co.uk
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|