Jack,
If you need to remove or replace the crank with the block on the stand, then
the plate has to come off. Then the complication is fitting the bolts on
your stand to the bolt holes in the block. The block may be too narrow for
the stand (mine was). Then you'll have to cobble it together somehow.
Regards,
Hugh Fader
> -----Original Message-----
> From: owner-triumphs@autox.team.net
> [mailto:owner-triumphs@autox.team.net]On Behalf Of jack williams
> Sent: Saturday, January 18, 2003 1:49 PM
> To: Triumph list
> Subject: mounting engine
>
>
> I know I have seen this before, and I was sure I saved the
> e-mail, but I sure
> can't find it now. I'm about to start work on my motor. Is it
> best to remove
> the large plate on the back and bolt the engine stand
> directly to the block,
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|