Just because I am cheap and there is a lightened flywheel on ebay
right now. I got a drawing from Jack Drews showing how to lighten my
TR4 flywheel to 20lb but it will take a lot of care to locate the
TR4A/TR6 clutch pressure plate properly ('cause I want to fit a
diaphragm type p.p.)
I guess I'll have to do it and no doubt I will be proud of my prowess
when I am done ;-)
Francois
--- Gerald Van Vlack <jerryvv@alltel.net> wrote:
> I gotta ask, why would you want to if you could, which I don't
> think you can?
> JVV
> ----- Original Message -----
> From: francois wildi
> To: triumphs@autox.team.net
> Sent: Tuesday, November 05, 2002 8:01 PM
> Subject: can I fit a TR6 flywheel on a TR4 engine?
>
>
> Listers,
> I have a few questions regarding the rebuild/upgrade that I am
> just
> starting. It seems to me that it should be possible to fit a TR6
> flywheel on a TR4 crank since the TR4A uses the same pressure
> plate
> and the same disk as the TR6. That is if the bolt pattern on the
> crank and the ring gear diameter are the same of course...Do you
> know?
>
> Thanks in advance
>
> __________________________________________________
>
__________________________________________________
Do you Yahoo!?
HotJobs - Search new jobs daily now
http://hotjobs.yahoo.com/
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|