Scott,
It is welded to the pipe, but maybe yours is attached the wrong way around?
As someone else mentioned the hole in the bracket goes under the right hand
coil bracket bolt.
You have the pipe the right way; maybe you have to bend that tab somehow to
make it fit.
On a side note, you can get these pipes in stainless steel from the usual
suspects. I put one on my car during the engine rebuild - looks great and
I'm now less worried about pinhole leaks anytime soon. But its mounting tab
was quite too long - I cut off the end and drilled a new hole.
Regards,
Jim Wallace
2TS81417L
>...I have a question regarding the fitting of the
>heater return water pipe. Is the bracket that secures the pipe
>to the block supposed to be welded to the pipe ... If it
>does face away from the block, what secures it?
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|