In a message dated 8/12/02 11:49:50 PM Eastern Daylight Time,
ryoung@navcomtech.com writes:
> and remove 4 bolts under the hood that hold the apron cross brace to the
> brackets on the inner fenders
Randall:
These fit a 7/16 socket. Problem is the nuts turn with the bolt. They are not
rusty either. The heads on the inside appear round, therefore I can't get a
grip on 'em with a socket or wrench. Also a vice grip is hard to get in there
and even if I find a small vice grip the head is hard to grip as it's quite
narrow, almost flat.
Any suggestions?
Ray Antoky
59TR3A
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|