Message text written by "Kevin Kealty"
>Hi all. Is there any way to remove a broken bleeder from the front
caliper
(TR3B)? As luck would have it, I had successfully bled 3 wheels and the
fourth broke off.
<
Sorry to hear about that. You may have a serious problem here. Or you
could do what I did: bleed at the hydraulic connection. This is less than
perfect but it will bleed the lines.
I figure I'll have to rebuild the calipers osme day and at that point I'll
resort to heat of some other extra steps to get them loose. Until then,
I'm soaking them with penetrating oil.
BTW, since you have a 3B I assume you have the TR4 calipers without the
cross-over pipe which means there is an internal passage with the fabled,
mystical O-ring that may suffer damage if too much heat is applied to the
caliper.
But for now I'd suggest you bleed them at the hose fitting and see if that
works.
Dave
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|