Hi List!
I was planing on installing new Wet Sleeve Cylinders in my TR4/A engine
& was planning on follow Brian S's hold-down method, of using the Head
Studs with washers & pipe as hold-down, on the cylinders once inplace
with gAsket sealer & Fig. "8" joint gaskets.
A club member suggested not to install the Head Studs yet because of
grtting in the way when turning the engine. He suggested that I use
washers & bolt. Then just before you're ready to install the head,
that's when he says to remove the bolts & washers to install the Head
Studs. I'm interested in the members oppion that have been there,...
________________________________________________________________________
Check your overdrive pressure in the car if you think that the
overdrive is not performing to snuff. Buy the pressure gauge and
adapter for $55.50, including shipping in the US, from Bolt-On Healeys,
82923 Bear Creek Rd., Creswell, OR 97426. Email: tricarb@aol.com. Use
Visa or M/C.
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|