Bill,
I was considering the very same approach - but how do you peen over the
ends of the new studs?
Regards,
Jim Wallace
http://www.triumphaddenda.com
||||||||||||||||||||||||||||||||
Paul,
I used a Dremel tool to grind down the inboard part of the stud that was
peened over. Was careful to:
Not grind on the hub itself, and
Not to get anything into the rear axle bearings.
Unscrewed the studs by running two nuts back-to-back. Installed new studs
the same way.
Bill
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|