Paul,
I used a Dremel tool to grind down the inboard part of the stud that was
peened over. Was careful to:
Not grind on the hub itself, and
Not to get anything into the rear axle bearings.
Unscrewed the studs by running two nuts back-to-back. Installed new studs
the same way.
Bill
In a message dated 7/6/01 1:00:01 AM Eastern Daylight Time, PMSchuess@aol.com
writes:
>
Bill Babbitt
TR3A in a bag
Gales Ferry, Ct
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|