Hi,
Since I'm switching from wire wheels to Minilites, I need to change to
longer wheel studs. Getting the old studs out is no problem: just pop them
with a dead-blow hammer. However, I spent two hours with an impact wrench
and a long bar and managed to get two new studs in. These things have a
splined interference fit with the hub. Putting a spacer between the lug
nut and the hub, I've been using my impact wrench to start pulling the stud
in, then finishing with the long bar and a socket.
Is there an easier way?
Thanks,
Cliff Hansen
hansenc@flash.net
1966 TR-4A CTC 64615L (now, with floors)
///
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
///
|