Mark :
Did you have both half-shafts in place when you measured end play ?
It's important ...
If so, my next guess would be that the center 'button' is missing, P/N
111215 (at least for TR3A, I assume the TR4 is the same).
AFAIK, not pressing things on far enough can only make the bearings too
tight. If the shim pack is bigger than your free play, perhaps that's
what happened, and the DPO added shims to compensate.
Randall
59 TR3A
Twistblts@aol.com wrote:
>
> When the whole assembly was back in the axel housing, there was
> more than 1/8" end play in the axel (after the castellated nut was tightened
> to the appropriate torque).
///
/// triumphs@autox.team.net mailing list
///
|