Hi Randall,
Any suggestions on what to use for the stanchion to body sealing
rubber?
Thanks,
Drew
On Sep 2, 4:27pm, Randall Young wrote:
> Subject: Re: TR-3A winshield installation
>
> If you look at the stanchion in the highly curved area that matches the
> curve of the scuttle, above the groove for the stanchion to body sealing
> rubber (which Moss does not list), you should see two holes, about 3/8"
> apart. There are two small screws (also not listed) that go through the
> 'finisher', through the windshield to body rubber seal, and into those
> holes. (Unless of course the holes are full of broken off screw, as my
> stanchion from the parts bin is <g>) The screws appear to be factory
> P/N YJ.2182
>
> Randall
> 59 TR3A
>-- End of excerpt from Randall Young
--
Drew Rogge
drew@pixar.com
|