I agree. This is a job for the NIBBLER.(sounds like a Bat Man character). I
don't know how inexpensive they are, but they are sure handy to have.
They're a right angle setup so should fit up where you ned it. Just don't
let the little nibbles get into your carpeting and for sure don't go
crawling around on them. They hurt like hell going in and coming out. No, ya
don't need to ask.
Rob robertson
Seattle
----- Original Message -----
From: <DRSkruffy@aol.com>
To: <triumphs@autox.team.net>
Sent: Tuesday, July 04, 2000 5:24 PM
Subject: Re: Tools for body sheet metal?
>
> In a message dated 7/4/00 11:53:15 PM !!!First Boot!!!, hansenc@flash.net
> writes:
>
> << I need to cut some small rusty pieces of sheet metal away from the
> firewall, in a tight location up under the dash. My hacksaw and Sawzall
> won't fit up under there and I don't own a plasma cutter :-)
>
> I thought the right tool was aviation snips, but I don't own any of these
> either (yet) and its been many years since I did anything like this.
> >>
>
> How about one of those inexpensive "nibblers?" I got one when I went to
JC
> Whitney's several years ago.
>
|