It's not a pin that passes through..it's a sprung clip thingie...press it in
and pull the knob off. Yes, it helps to hold the wooden dash onto the
underlying metal frame.
ken shapiro
baltimore
1970 GT6+ KC81872L
----- Original Message -----
From: <OHFASTONE@aol.com>
To: <triumphs@autox.team.net>
Sent: Monday, May 15, 2000 2:14 AM
Subject: Now I've got questions
>
> Listers,
> I was out back pulling the dash out of my 72 GT6, two thirds of it came
out
> with no problem. The left hand section is where the difficulty arose, I
> can't get it loose. Plus, on this same section is the washer/wiper
switch.
> In trying to remove the knob, I noticed that it is retained by a pin
pressed
> through the knob and into the shaft. Problem is, it does not appear to
screw
> in and there is no hole on the opposite side to press it out. Before I do
> what crossed my mind, Iwant to hear what you have to suggest.
>
> Michael
>
|