Hi Paul
I use Wellseal, this is basically the same thing you already find on the
gaskets, so is compatible with them, some gasket mfrs recommend no gasket
goo be used unless the engine mfrs say otherwise, I was really impressed by
the Wellseal, though it is expensive by comparison to red hermetite etc it
is easy clean so should not pose the same sort of problems as hermetite.
Graham.
----- Original Message -----
From: Paul J. Burr <tigerpb@ids.net>
To: Triumphs (E-mail) <triumphs@autox.team.net>
Sent: Thursday, May 04, 2000 1:52 AM
Subject: Head gasket sealer.
>
> To the Collective Wisdom:
> I'd like to know if any of you have used any type of head gasket
> sealant/adhesive when installing a new head gasket. Or, is it best to
> install it "dry"?
> Also, any recomendations on a vendor for push rods would also be welcome.
> Thanks!
> Paul Burr
> '73 TR6 (getting a new motor soon!)
>
|