George :
I found it easier to drive the plug out separately from the bearing
(mostly because the tool I made up would only pull towards the front of
the block), but you've got the general idea.
BTW, TR3s do not require line boring after the new inserts are
pressed/driven into place. Note that the rear insert can only go one
way, to have all three holes line up. (If they don't, your rockers won't
get oil.)
Randall
George Richardson wrote:
>
> That's fine for the 2 in the block, but what about the one at the rear
> of the block. Do you just drive it out the back, along with the steel
> plug in the back?
>
> I can easily make a drift myself on the lathe.
|