At 10:31 AM 2/7/00 -0500, Rob Christopher wrote:
>To solve this, break off the spade tab that was unused and spread some silicon
>on the top of the switch body to insulate that connection. You need to also
>spread some silicon on the other top connector. Just enough to insulate the
>part of the tab not covered by the connector on the wire under the dash. You
>can also use heat shrink to insulate this one. Put the switch back in and all
>should be OK.
A somewhat less drastic solution would be to place an insulated spade
connector on the non-connected lug. Then put heat shrink tubing on the
connected one. You might find a need for the other one someday, or a
concours judge might disassemble your dash...
Jeff Scarbrough
|