In a message dated 00-01-11 20:34:02 EST, jays@paonline.com writes:
<< The exhaust manifold has broken off around one of the bolt holes. It is
at a hole where there are 2 exhaust ports and about 1/3 of the
circumference around the hole is missing. Is this going to be a problem?
I could not find new ones listed. The manifold is in good shape otherwise.
Is it worth trying to weld. I think cast iron needs to be preheated before
welding. >>
Based on my recent experience with the Spit - same area of the manifold -
lot's of attempts at bonding with fillers, adhesives, etc.....I decide to
replace the manifold and I'm glad I did...less noise of course but more
strength to the exhaust system as well.
chip
Chip Krout
'76 TR6 CF57822U (restoration underway)
'70 Spit Mk3 FDU78512L (enjoying winter under cover)
|