Cosmo,
Easy, just measure the internal diameter. In this case, you'll be
looking for a maximum allowable diameter measurement. I can't give you
that for a 240Z drum, but would be willing to bet you'll find it cast
into or stamped onto the drum somehwere. Drum and rotor manufacturers
are required to do this and servicing shops are required by law to abide
by the manufacturers' dimensions, both for safety reasons.
Alan Myers
San Jose, Calif.
'62 TR4 CT17602L
J&E wrote:
>
> Hello List again!
> Another question popped into my head reguarding AL. Fin Rear Brake
> Drums. I have learned that the AL Fin Drum has a steel lining inside the
> drum. Which makes sense. My question is: if one is to obtain a used set
> of AL Fin Drums, then how does one know if the are reusable? or If
> turned down beyond "safety" spects? I shall post any "off line"
> responces back to the TR List. TIA -Cosmo Kramer
--
MZ
|