At 11:27 AM 8/29/99 -0700, you wrote:
>
>There's a diagram of this tool in the Moss catalog. The section of the
>TR2/3/4 catalog with the diagram is at
>http://www.mossmotors.com/cataloglayout/pdfs/tri/trii.pdf
>(It's probably in the TR6 catalog too)
>
>It also has the suggestion to coat the "small V" with upholstery
>adhesive to help hold the clip in the tool.
>
>Randall
>
>Jim Davis wrote:
>>
>> Bob,
>> If you have a Haynes manual, on page 221 (fig. 12.17) there is a drawing
>> of a tool you can easily make for installing the spring clips .
>
The tool as described in the various catalogs and manuals is invaluable in
installing the clips. One more tip - the last clip is usually too short to
properly hold the seal in place - if you find this to be the case, use a
door clip from a Spitfire here - they are a bit longer and hold the seal
much better at the rear.
Good luck!
Brian Schlorff
Power British
|