To: | Chip19474@aol.com |
---|---|
Subject: | A Spit Tip |
From: | "Bradley C Kahler" <bkahler@omc.ja.dtra.mil> |
Date: | Sat, 19 Jun 1999 00:12:12 -1000 |
Cc: | triumphs@autox.team.net |
>It's not bad so I cut a small piece of hard rubber tubing, slit it to fit >around the tubing and snugged it in the hole.....developing a fuel leak on a >hot engine would not be a good thing! Chip, those brackets originallly had rubber grommets in them to keep the steel lines from rubbing. Your fix is as good as any! Brad (stuck in the sunny mid pacific) |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | References for roll bar and seat belt installation?, Steve Myers |
---|---|
Next by Date: | 2 TR7s ; $200 ; Phila. PA USA, Kai Radicke |
Previous by Thread: | A Spit Tip, Chip19474 |
Next by Thread: | Mosport Info? (LBC Content low), dncullig |
Indexes: | [Date] [Thread] [Top] [All Lists] |