Hi all
I removed the hood from my 73 TR6 this past week, and was careful to make
sure that I marked the position of the hindges on the hood to make
reistallation easier. I put it back on last night, but I was unable to get
the lines to match up again -- off by about 1/16 to 1/8 inch. Close but not
right and the hood when closed is not square to the fenders. It was good
before. Is there a trick for getting the final adjustment -- that is for
making a fine adjustment to the position. The Bentley's does not offer any
suggestions.
Any help much appreciated.
Cheers,
Mike Graham
-------------------------------------------------------
Michael Graham: mgraham@achilles.net
Tel: 613-258-2901; Fax: 613-258-1819
Home Page: http://www.achilles.net/~mgraham/
|