I need some input on from this experienced group on some
of the best ideas to handle/support the TR6 body while it's off the
chassis. I've seen wooden rolling racks that fit over the chassis and
wheels, putting the body at eye level and only using 1 spot in the
garage. I've also seen a pulley system that the body hangs from (fully
supported at the right spots), attached to the garage rafters.
Your ideas and suggestions would be greatly appreciated.
The chassis is shaking with fear knowing I'm about to get up close and
personal. The adventure continues!
Tom Di Iulio
76 TR6 (in pieces)
CF56452
Denver, CO
|