HELP!!!
I am trying to remove the front nut that holds the pulley on at the front of
the engine.
The engine is a 76 SPIT 1500.
I currently have it on a stand so there is no flywheel. I have tried to hold
the pulley with a pipe wrench and loosen the 1-7/8" nut with a breaker bar....
Couldn't hold the pipe wrench on... I then attached the engine hoist chain on
the crank via the flywheel bolts and I broke the chain.
It looks as if the engine rotates clock-wise as looking at it from the front.
I am wondering... is this nut a left hand nut? I was assuming it was a right
hand but am not sure!?!
Do I need to heat it with a torch?? Or attach some flat bar to the crank bolts
and wedge it against the engine stand!!
HELP!! NEED SUGGESTIONS!!!
Getting aggravated fast!!,
Thanks,
Erik
|