Wayne,
Another place that has what you need in stock (I know, because I'm in the
midst of rebuilding my TR3B (TR4 engine)) is British Frame and Engine (626)
443-0939. Pretty good prices, but the best part is you get to deal with Ken
Gilanders -- who can answer any and all questions.
I also had Ken rebuild my oil pump --- I think the total cost for that was
$40.
Good Luck,
Dave Moag
77 Spitfire
62 TR3B
> -----Original Message-----
> Rengrave@aol.com wrote:
>
> Hello everyone,
>
> I am about to perform my first Main bearing and Rod bearing
replacement due to
> low oil pressure and noise when I rev engine.
> I am told that I should use Plasi-Gage to determine the
amount of wear on each
> bearing, is this easy?
> I am also going to replace my original oil pump while I am
at it, the pump is
> worn with deep lines on top of every lobe on the center gear.
> My question is : Where is the best place to purchase new
Bearings, Thrust
> Washers and a new Oil Pump? TRF?
>
> Wayne from Massachusetts
> 1973 TR6 Mallard/New Tan
>
>
>
>
|