These should be split along the side, slipped onto the axle and held in
place with tie wire. If you don't like the wire, which tends to start
rusting before you've finished tightening it, you can use large hose
clamps.
Cliff Pike wrote:
>
> Hello listers,
> Thanks to all who responded with much appreciated advice to my previous
> postings.
> I have just received two new bump rubbers, which are slid over and
> attached to the rear axle of the TR3A. Maybe I'm missing something, but
> the only way I can see to install these is to remove the axle tubes from
> the differential housing. My service manual gives no procedure for doing
> this. Is this what I must do, and what is the best way?
> Cliff Pike
> '58TR3A TS30767LO
> '66 Spitfire4 MKII
> '64 Spitfire4
>
> --
> .........Come visit us at http://www.mgl.ca/~cpike/home1.htm
--
George Richardson
The Wyvern - '57 TR3, TS15559L - Now on the road!
http://www.merlingroupinc.com/tr3.htm
|