Jim
As Bob Roberts mentioned the windshield posts go through clamps that hold
the whole frame tight to the body. When I removed the assembly from a
TR250 I parted out I just removed the bolts and took the whole frame off.
I was not aware that the clamps could be loosened as Bob said, but as I was
parting the car out I wasn't very gentle with it. If those clamps could be
loosened that would make the procedure a little easier.
John
At 03:01 PM 11/11/98 -0600, Gambony, Jim wrote:
>
>John,
>
>Isn't there a bracket (or two) in dash top area that also bolt it down? I
>know the early GT6s (pre-MkIII) had the brackets.
>
>
>Jim
>
>> -----Original Message-----
>> From: John Richardson [SMTP:johnr@intellicorp.com]
>> Sent: Wednesday, November 11, 1998 2:43 PM
>> To: Ct54531@aol.com; triumphs@autox.team.net
>> Subject: Re: Windshield
>>
>>
>> Jon if I remember correctly, it is indeed just the two bolts that holds
>> the
>> whole frame to the body.
>>
>> John
>>
>>
>>
>>
>>
>>
>>
>> At 02:30 PM 11/11/98 EST, Ct54531@aol.com wrote:
>> >
>> >Listers:
>> >
>> >How is the windshield frame attached to the body? Is it just the two
>> bolts on
>> >either side just under the fender in front of the door? I want to replace
>> the
>> >seal that goes in between but what's there now isn't so bad if the job is
>> a
>> >pain.
>> >TIA.
>> >
>> > JMac
>> >
>> >
>
>
|