Does anyone have a good way of measuring the depth of the jet in a ZS carb?
I need to measure from the top of bridge in the carb to the top of the jet in
fairly fine increments of measure, (e.g 64ths of an inch or at least 32nds of an
inch) in order to set the jet at the right depth. I'm told that the proper
range of depth is O.110 inches (approx. 7/64 inch) to 0.120 inches (approx.
8/64 inch) inches deep for Denver's altitude so you can see there is little room
for error.
Is there a special tool that the pros use to set the jets at the correct depth?
Or does anyone have a home-made method that has worked for them? What depth
have you set the jets at?
Thanks
Bud 71 TR6 CC57365
|