Last night I removed the old seat cover and foam from the passengers seat
for my '76 TR6. I now have several questions for the list.
1) When looking at the seat frame from the front, the right side (by the
center of the car) seemd to be perpendicular to the floor, but the left
side (outside of seat) is bent inward at about a 15 degree angle. Is this
correct?
2) How tight should the seat back webbibg be? A couple of the back straps
can be removed with very little streching.
3) What should be used for foam inside the headrest? The seat foam kit
from TRF had a piece of foam 11-1/2" x 9-1/2" x 5/8". Is this for the seat
bottom (center between the larger seat bottom piece) for should it be
folded for the headrest.
4) What is he best type of spray adhesive to use?
Sorry for all the questions, but this is my first adventure in redoing
seats.
Frank
'76TR6 CF57007U
|