At 7:52 AM +1000 16/10/98, Jim Hill wrote:
>You could just order them from the SpeedBleeder folks and tell them that
>they're for a TR6 (and that you want one for the clutch as well) and
>they'll send you the correct size.
Jim
That is exactly what I did and they sent me FOUR Speedbleeders! Seems they
forgot the clutch or could not supply the correct size. This did not
inspire confidence particularly with a car where the brakes changed mid
production.
The part number is SB3824, which translates to 3/8 x 24 pitch and 1.1
inches long. I have not yet tried them, so I cannot guarantee that they
even fit the brakes (late model, I believe).
The clutch is my current problem and I may see if they fit the slave
cylinder. However I suspect that they were intended for the brakes.
Perhaps the brakes and the clutch are the same.
Does anyone have a list of the obscure screw threads on a TR6? The Repair
Operation Manual appears to specify some, but not all. For instance, are
all the grease nipples 1/8 BSP?
Regards, Trevor Jordan
74 TR6 CF29281U
|