In a message dated 98-09-04 07:36:01 EDT, lee.k.janssen@lmco.com writes:
> After removing a spinning wheel stud on the front hub of my TR6 I noticed
> that the hole is enlarged to the point where the new stud does not generate
> a tolerance fit. As a result if I insert a new stud it will only be a
matter
> of time before it too will start spinning. Since a new hub is $190 I was
> wondering if anyone has a way to cure this problem.
Lee,
One option is to use a larger stud, either a larger diameter, or one with a
larger knurl diameter if you can find one. Take the hub to a machine shop to
drill out the holes to fit.
This morning, I'm taking the hubs from my TR6/Ford 302 to the machine shop to
have 1/2" studs installed, to match the 1/2" studs on the Ford 9" rear end I'm
using. Both the stock wheels and the Panasports I'm using will accept the 1/2"
studs with no problem. Lug nuts are available that will at least nearly match
the stock nuts, but you may have to buy 16 new ones to get a perfect match.
I'll let you know this afternoon what success I have, and how much it cost.
The studs cost me $9.
If the hole is not too large (but from your description, it sounds like it
is), the use of one of the stronger Loctite compounds may help.
Dan Masters,
Alcoa, TN
'71 TR6---------3000mile/year driver, fully restored
'71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
http://www.sky.net/~boballen/mg/Masters/
'74 MGBGT---3000mile/year driver, original condition - slated for a V8 soon
'68 MGBGT---organ donor for the '74
|