Re: TR6 Main Bearings

["Irv Korey" <emanteno@ix.netcom.com>]

> From: Martin Libhart <mlibhart@feist.com>

> Here's my question - with the crank still in place, there's no way to
> mic the
> journals to check for wear. I plan to replace with std. size shells. How
> best
> to determine if there has been enough wear on the journals that std.
> size
> would not be appropriate? 

If the crank has been cut from standard by a PO, the size will be stamped
into the non bearing side of the shells. Look there, if there is no size,
your bearings are standard size. 

Irv