Richard Taylor wrote:
> I recently read about the clutch slave cylinder on the list
> and the bleeding of the slave. I am wondering, my slave
> cylinder is mounted with the bleeder screw on the bottom - is
> this correct? I am not sure how you would ever get the air
> out if this is correct. My clutch works, so I am wondering
> if it matters
Rick,
Your clutch slave cylinder is mounted upside down. Given
that your clutch works, I wouldn't change it now. However,
the next time that the clutch hydraulics need to be bled,
it would make a lot of sense to remove the slave cylinder
and then mount it again right-side-up.
--ken
VTR WWW Maintainer -- http://www.vtr.org
--
Kenneth B. Streeter | EMAIL: streeter@sanders.com
Sanders, PTP2-A001 |
PO Box 868 | Voice: (603) 885-9604
Nashua, NH 03061 | Fax: (603) 885-0631
|