-----Original Message-----
From: David Hill <David_J_Hill@email.msn.com>
To: Triumphs@autox.team.net <Triumphs@autox.team.net>
Date: 22 May 1998 19:38
Subject: Rockerpanel dismantling tips
>
>Hi, Sebastien and Gaby
>
>If you're futting a full rocker panel, get a spot weld drill and take out
>the old welds. They're easier to find if you wire brush the paint off the
>seams.
>
>If fitting a part panel and have a good air compressor, use either an air
>saw or air nibbler to cut along the panel. Failing that, an electric jig
saw
>or reciprocating saw both work well. I use a carborundum grit blade-they
>last longer.
>
>Some people use an air chisel or a hammer and bolster chisel. This is a
>brilliant way to make a hash of the job.
>
>All the best, Dave hill.
>
>
>
>
>
|