Joseph Sholtes wrote:
>
> Marty,
>
> I just installed new bushings in my TR 250 a month ago. I used
> list info (heated them up, figgured on a difficult install, and used silicone
> spray lube) to make it happen. I do have one question though, when I
> began installing mine, I didn't remember whether to put the thick, washer
> like area or the thin, tapered end in the engine bay area. Since I was set
> to do the job, and not in the mood to stop, I went ahead and did it. I put
> them in from the engine bay side, with the thicker part in the engine bay,
> and the thinner part inside the car. Did I do it right?
>
> JOE IV
> TR 250
> WALLINGFORD, CT. USA
Joe, when I did mine, I put the thin tapered area into the engine bay.
I'm not sure which way is "right" but it would seem to me that either
works fine.
Marty Romagni
1974 TR6
Painesville, Ohio
|