Just wanted to say thanks to everyone who responded about my Mystery
Rear Fender Lower Trim Bits.
A summary of the responses:
First, there is actually someone on the list who prefers to work even
later than me! My post asking for information was sent at 2:30 AM,
Friday morning, after which I trundled off to bed. Richard Kramer
actually replied at 3:12 AM, with a follow-up clarifying post at 3:29
AM. (I guess it took a few minutes to find a flashlight before he could
go roll around under his car! :^)
At any rate, the part in question is apparently called a "finisher -
wing lower", and it installs over the spot welded flange at the bottom
rear of the quarter panel, secured in place with a small weld at either
end. (I wasnt sure if the welds were a DPO bodge, but Barry Schwartz
provided confirmation that they were factory. (Take note Tom O'Malley)
The reccomended sources were Matthews in B'ham AL, Kipping & Rimmer
apparently list it, as does TRF. The consensus was a price under 20
bucks per side.
Thanks to all for the speedy replies. I'll be ordering them soon.
John
http://www.jacksonville.net/~suchak/toys.htm
|