Re: Release bearing removal

[tomomalley@hey.net (Tom O'Malley)]

Ed writes...
>
>What have some fellow listers used to drive out the pins in the
>operating lever to get the old bearing out?  I sure don't have a drift
>that small.  The Haynes manual suggest using a sawn off nail -- of which
>I don't seem to have one that fits.
>
>Best regards,
>Ed Hamilton
>'80 Spitfire

Ed...is this the clutch release bearing you're trying to replace?

If so,  it's just held on by a light press fit.  No need to remove any
pins.

Cheers!
Tom O'Malley
'74, '77 Spits