I have a strange gearbox, and I am putting in some rubber mounts to
replace the
wooden ones I have in there as a temporary patch. The chassis has the
plate
for an overdrive gearbox in, but no O/D mount. My gearbox has not got
the
holes in the right places to put the standard mounts in. It just has
the
holes in the bottom thing. What I want to know, and I can't find this
in
any book I have, is what is the distance between the top of the chassis
members, and the bottom of the gearbox extension housing. I need to
know
to make my mount I have designed.
Ascii art to follow...
(O) |88#8888(
===== | =
%% %% %%%%%%%%%%%
%%---------%% %%%%%%---%%
(0) and ( = the output shaft,
8 = the extension housing
| = the gearbox
# = standard mounting point
= = the bit I want the distance from with the holes where I am going to
put
the mounts I am going to make
% = chassis rail
- = the overdrive mount plate, minus mount.
Many Thanks
James, hoping someone out there has a tape measure, and is in the area.
--
James Carpenter
Yellow '79 spit wired by a trained marmot
|