In a message dated 2/3/98 12:30:29 PM Eastern Standard Time, drew@pixar.com
writes:
> Does anyone have any recommendations for books on learning sheet metal
> fabrication? At some point I'm probably going to be making new channels
> for the boot of my 3A and I thought I might bone up a bit on the subject.
Drew:
1) "Sheet Metal Handbook" by Ron and Sue Fournier, ISBN 0-89586-757-5
2) "Metal Fabricators Handbook" by Ron Fournier, ISBN 0-89586-171-2
Both are published by HP Books. Both are aimed towards automotive
applications. Both are excellent, or at least seem to be to this amateur.
Dan Masters,
Alcoa, TN
'71 TR6---------3000mile/year driver, fully restored
'71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
http://www.sky.net/~boballen/mg/Masters/
'74 MGBGT---3000mile/year driver, original condition, slated for a V8 soon!
'68 MGBGT---organ donor for the '74
|