Edward Lancaster wrote:
> I tried changing the oil in the TR 6 for the first time this
> weekend and could not remove the oil plug. I quit trying to
> force it for fear of rounding the head. The plug seems to be
> in good shape and there are several threads showing outside
> the oil pan. Does anyone have a suggestion for removing the
> plug? Is there anything I can do to avoid this problem when
> reinstalling the plug?
The plug, being a square bolt, will tend to be rounded off
by a socket or wrench not intended for square bolts.
I would suggest going to your local Sears, and plunking down
about $4.50 for a single 7/16" 8-point socket. This will
fit the plug properly, and keep it from getting rounded off.
You'll also need this socket when it comes time to top off
the transmission or rear axle (differential) oil.
If your current plug is rounded off too badly, use vice
grips to remove it, and order a new plug from your favorite
TR6 vendor -- it should cost less than $2.00.
--ken
'70 & '74 TR6 Daily Drivers
--
Kenneth B. Streeter | EMAIL: streeter@sanders.com
Sanders, PTP2-A001 |
PO Box 868 | Voice: (603) 885-9604
Nashua, NH 03061 | Fax: (603) 885-0631
|