Shane F. Ingate wrote:
>
> Scions,
> WIth all this talk of external oil feeds, could someone
> post instructions on how to fit one of these kits to a TR6? Does it
> need more tools than a torque wrench?
> Thanks in advance,
> Shane Ingate in San Diego
All you need is the finesse of a safe cracker to tighten the banjo bolt
on the head. When I first installed mine, it just was not tight enough
and leaked "just a little". Titghtened it "just a little" and snapped
the head of the banjo bolt right off! Got some replacements from TRF
(they have the bolts in stock, but you have to wait a few weeks) tried
it again and have not had any problems since. I would suggest that my 6
does not experience oil loss, however, I don't want my LBC to hear ne.
The rest of the installation is straight forward and should take about a
half hour.
george leicht
glite@eos.net
|