Was browsing through the instructions in the Haynes manual for the
procedure to remove the rear fender, and two steps confuzzled me...
It says I have to remove the rear bumper. Why is this? It looks like I
can just lift the fender straight up after unbolting it.
It also says that I should remove the 'quarter trim panel'. Where is
this? If it's in the trunk then I don't have it :-)
BTW in addition to all the methods described, I use the old gas (the BAAD
GAAS) that I removed from the tank to dissolve the asphalt undercoating.
Just slop it on and wipe it off. I have already disposed some of this
stuff by burning it, it's pretty dead-- I poured about a cup into the
burn barrel and lit it, it went woof and then went out. Had to toss in
some paper and rags to get it to burn %-O
-Malcolm
Too many rocks and not enough sand.
|