In a message dated 97-05-26 21:58:49 EDT, leew@arn.net (Lee Waters) writes:
> Bought a glovebox for my TR-6 from VB. It was quality material but had
> difficult time on installation. I had to wet it, bend it and crush it to
> make it fit. Has anyone else had problems with this or know of someone
> that makes a better fit.
Lee:
I've installed two that I bought from TRF. They are a tight fit, but I didn't
have to go to all the contortions you say you did. The boxes from TRF are
plastic.
Dan Masters,
Alcoa, TN
'71 TR6---------3000mile/year driver, fully restored
'71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
www.sky.net/~boballen/mg/Masters/
'74 MGBGT---3000mile/year driver, original condition
'68 MGBGT---organ donor for the '74
|