Re: Wheel Bearing End Play & Grease Seals

[npenney <npenney@erols.com>]

>If I had to do this again I would probably get the seals from VB (the ones
>with the small ID), carefully remove the felt, and grind the ID to a point
>that they would fit over the little "hubs" on the inboard side of the spindle.

For a part that common, I'd rather go with some place like Napa or a 
distributor of 
Beck and Arnley parts so I wouldn't have to play shipping games and such.  Much 
easier 
to deal with problems of mis fit when I can have both parts in hand and discuss 
it over 
a parts counter.