Michael writes:
< snip >
> not having any of the special tools for rear halfshaft work, is
> there any way to figure out which part is actually bent? when
> you spin the drum, you can see the gap between the drum and the
> backing plate vary, but the shaft appears to turn true, at least
> to my uncalibrated eye.
***************************************
Take the drum off and examine the mating flange for flatness. If the 'ears'
are bent, then it's a good bet your axle hub/flange is bad. If these are
flat, then it's most likely your axle assy -
Barry Schwartz
Bschwartz@encad.com (San Diego)
72-V6 Spitfire (daily driver)
70 GT6+ (when I don't drive the Spit)
70 Spitfire (project on hold for now)
|